Miller XT30C 소유자 매뉴얼 - 페이지 19
{카테고리_이름} Miller XT30C에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller XT30C 40 페이지.
Miller XT30C에 대해서도 마찬가지입니다: 매뉴얼 (40 페이지)
4-6. Connecting Gas/Air Supply
Tools Needed:
5/8, 1-1/8 in.
From Gas/Air
4-7. Connecting Work Clamp
2
.
A complete Parts List is available at www.MillerWelds.com
3
2
Supply
4
1
1
.
Use only clean, dry air with 90
to 120 psi (621 to 827 kPa)
pressure.
1
Gas/Air Inlet Opening
2
Hose
3
Teflon Tape
Obtain hose with 1/4 NPT right-
hand thread fitting. Wrap threads
with teflon tape (optional) or apply
pipe sealant, and install fitting in
opening. Route hose to gas/air
supply.
4
Air Filter/Regulator
Adjust gas/air pressure according
to Section 5-1.
802 787-C / Ref. 801 319-C / Ref. 804 486-B
1
Work Clamp
2
Workpiece
Connect work clamp to a clean,
paint-free location on workpiece, as
close to cutting area as possible.
Ref. 803 640-A
OM-255 590 Page 15