Miller XT30C 소유자 매뉴얼 - 페이지 21

{카테고리_이름} Miller XT30C에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller XT30C 40 페이지.
Miller XT30C에 대해서도 마찬가지입니다: 매뉴얼 (40 페이지)

페이지 인쇄
Miller XT30C 소유자 매뉴얼

4-11. Installing Alternative Plug

.
This procedure is necessary if the unit is to be connected to a 230 VAC receptacle,
or to a 115 VAC receptacle that requires a plug that is different from the supplied plug.
.
See Section 4-10 for instructions on setting changeover switch for proper voltage.
Tools Needed:
Notes
.
A complete Parts List is available at www.MillerWelds.com
6
7
1
2
3
4
5
1
Supplied 115 VAC Plug
Cut cord close to plug.
2
Alternative Plug (230 VAC
Plug Shown)
3
Load 1 (Brass) Terminal
4
Load 2 (Brass) Terminal
5
Ground (Green) Terminal
6
Outer Shell
7
Cord Grip
Strip cord jacket back enough to
separate conductors. Strip conduc-
tors enough to make good contact
with plug terminals. Make plug con-
nections and reinstall outer shell and
cord grip. Tighten assembly screws
onto shell. Do not overtighten.
Ref. 801 305-A / 801 611
OM-255 590 Page 17