ABB FIO-01 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} ABB FIO-01에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB FIO-01 12 페이지. Digital i/o extension
ABB FIO-01에 대해서도 마찬가지입니다: 빠른 매뉴얼 (14 페이지)

• Insert the module carefully into the option slot on the control

board until the retaining clips lock the module into position.

• Fasten the screw (included) to the stand-off.

Note: Correct installation of the screw is essential for fulfilling the

EMC requirements and for proper operation of the module.

Terminal designations

Marking

X61, X62, X63,

X64

X65, X66

Wiring

Maximum cable size is 1.5 mm

2.5 mm

connected to the JCU-01 Control Unit. See the drive Hardware

Manual for more information.

Tightening torque is 0.3 N·m (2.7 lbf·in) for the digital I/O plugs

and 0.5 N·m (4.4 lbf·in) for the relay plugs.

Programming

The communication between the module and the drive is activated

by a drive parameter. See the drive Firmware Manual.

Description

• DIOx = Digital I/O. Input (default), push-pull or

open collector. Selection is made by parameter.

See the drive firmware manual for more

DIOx

information.

COM

• COM = Ground reference on option board

ROxNO

ROxCOM

ROxNC

(AWG 14) for relays. The cable shields should be

• ROxNO = Relay normally open

• COM = Common

• ROxNC = Relay normally

connected

(AWG 16) for digital signals and

Quick guide - FIO-01