Aquaox FLECK 5800 XTR2 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} Aquaox FLECK 5800 XTR2에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquaox FLECK 5800 XTR2 7 페이지.

페이지 인쇄

TOUCHSCREEN CONTROL FEATURES

Features of the XTR2 Touchscreen Control

• Full-featured easy to use graphical touchscreen interface

for programming, servicing, and diagnostics.

• Non-linear programming no longer requires cycling

through every parameter when programming/servicing.

Buttons and Symbols

NOTE: Not all buttons appear on all screens.

Regeneration Cycle Wheel

• Displays the regeneration cycle step the system is

currently in. The wheel rotates with each step so that the

current step is shown in green.

NOTE: On metered units, the "Treatment" step on the

Regeneration Cycle Wheel will flash when water is

flowing through the unit.

Home

• Displays the Home screen.

Regeneration

• Displays the Regeneration screen, which allows you to

start a regeneration and manually cycle through the

regeneration steps.

Settings

• Displays the Settings screen, which allows you to adjust

commonly used settings. Pressing this button while in the

Settings screen provides access to the Master Settings

screen, which allows you to fully program the valve.

NOTE: Due to the complexity of these settings and the

potential for errors, Master Settings should only be

accessed by your local water professional.

Diagnostics

• Displays the Diagnostic screen, which can assist

in performing maintenance and troubleshooting

performance issues with the valve.

Assistance

• Displays a name and phone number to call for unit

service.

Screen Navigation Arrows

• Displayed in the upper-left and upper-right corners of

the screen, these arrows allow you to navigate from one

screen to another.

Settings Arrows

• These arrows allow you to change the values of certain

settings when programming the control.

Alarm

• Displayed when an alarm has occurred; accompanied with

an audible alarm. Press to silence the audible alarm.

Error

• Displayed when an error has occurred. Press to display

the Error screen for more detailed error information.

Advance

• This arrow allows you to advance through cycle steps

during a regeneration.

Reset

• Displayed in the Diagnostics screen to reset Totalizer

and Peak Flow data and in Master Settings to reset

parameters to default settings.

• Press to save or accept changes in control configuration.

Cancel

• Press to cancel configuration and exit to previous screen

without saving.

Fleck 5800 XTR2 Quick Start Manual • 5