Aquaox FLECK 5800 XTR2 빠른 시작 매뉴얼 - 페이지 6
{카테고리_이름} Aquaox FLECK 5800 XTR2에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquaox FLECK 5800 XTR2 7 페이지.
페이지 인쇄TOUCHSCREEN CONTROL FEATURES
continued
Screen Features
Home Screen
Day and Time
Regeneration
Cycle Wheel
Assistance
Figure 10 - Home Screen
The Home screen is always displayed unless the control
settings are being configured or during regeneration. This
screen displays general information about the system and
allows you to start a manual regeneration or access control
settings. Features of the screen are described below, followed
by more detailed information about each feature.
NOTE: If no button is pushed for five minutes, the screen will
enter a power save mode. The unit will continue to
operate, but the screen will be blank. Touch anywhere
on the screen to exit power save mode.
• Regeneration: Press to start a manual regeneration.
• Settings: Press to access commonly used settings.
• Diagnostics: Press to view diagnostic data.
• Assistance: Press to display the name and phone number
to call for service.
• Regeneration Cycle Wheel: Displays the cycle steps the
valve will step through during a regeneration; the current
cycle step is always at the top of the wheel.
• Treatment: The unit is treating water
• Backwash: Water flows from the bottom of the vessel
to the top of the vessel to clean the media
• Draw: Brine is drawn into the media and then slowly
rinsed out
• Rinse: Water flows from the top of the vessel to the
bottom of the vessel to rinse the media
• Refill: Brine tank is refilled with water
• Next Scheduled Regeneration: Displays the next
scheduled regeneration in either time or volume,
depending on control settings.
6 • Fleck 5800 XTR2 Quick Start Manual
Next Scheduled
Regeneration
Current Cycle
Step
Diagnostics
Regeneration
Settings
• Day and Time: Displays the currently programmed day of
the week and time. This button will flash if the control has
been reset.
Regeneration
Regenerate the system on demand by pressing the
Regeneration button on the home screen. Manual Regeneration
can only be used while the valve is in the treatment position.
From the Home screen, press the Regeneration button
Regeneration screen appears.
Figure 11 Regeneration Screen
• Press the now button to begin a regeneration
immediately, or press the tonight button to queue the
regeneration for the programmed regeneration time (2:00
AM by default). Pressing the tonight button again will
cancel the manual regeneration.
• During Regeneration, press the
advance to the next cycle step. Once in regeneration, the
volume or time will be displayed below the
Day and Time
From the Home screen (displayed in Figure 10 above) press the
Day and Time button. The Day and Time screen appears.
Hour
Minute
Figure 12 Day and Time Screen
• Press the Day of Week, Hour, Minute, and AM/PM buttons
to adjust the values to the correct day and time. Press
the 12/24 Hour button to display the time in 12 or 24 hour
format. Press the
button when finished to return to the
Home screen.
. The
Return
to Home
Screen
button to immediately
button.
12/24 Hour
Day of Week
AM/PM