Aquaox C Series 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} Aquaox C Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquaox C Series 8 페이지. Clack head

Fig 1 Typical installation for well water systems

5. You do not need unions to install your water softener. If you need to remove it, the Clack WS1

softener has union couplings on the bypass valve that make it easy to put the water softener on

by pass and remove the filter system from the piping.

6. The drain line tubing (not supplied) is connected to a drain from the drain outlet using flexible

½" ID tubing. Note that the drain can run up above the WS1 softener and into a drain, it does

not have to drain down, as the filter backwashes under line pressure from your well pump. Most

plumbing codes require an air gap connection, so that if your sewer or septic tank backs up, it

cannot cross connect with the drain tubing.

7. Usually you do not want to water the garden or irrigate your landscaping with softened water.

This will require more salt than usual to be used and in some cases the sodium can build up in

the soil causing some problems to sensitive plants. It is often not difficult to run hard water

(not softened lines) to the irrigation thereby bypassing the water softener.

Clack WS1 Water Softener Installation Guide