Aquaox C Series 빠른 시작 매뉴얼 - 페이지 6

{카테고리_이름} Aquaox C Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquaox C Series 8 페이지. Clack head

11. See the Clack WS1 Service Manual for instructions on how to program and set softener. Your

softener is already programmed for the size tank you have, but you do need to set the current

time of day and program the water softener with your water hardness. When programming

add 2 or 3 grains of hardness to your water hardness as a safety measure if you have iron in the

water.

12. Start a manual backwash by pressing and holding the REGEN button for 5 seconds. After

softener has been regenerating for 20 minutes, look inside the brine tank, and you should see

that is has sucked out the brine. At the end of the regeneration (90 minutes) check to make

sure that the softener has added water to the bottom of the brine tank to make brine for the

next regeneration cycle.

Maintaining Your WS1 Softener System

WS1 Softeners require little maintenance. The primary task is to add salt to the brine tank a couple of

times a year. You can fill the salt tank to the top if wish and then wait until the brine tank is near empty

before adding salt again. Or you can add salt whenever you notice that the salt is low enough to add

more bags. If you fail to add to salt the water will turn hard again, and you will notice that there is

water in the bottom of the brine tank. This is normal, and you can add salt and press the manual

regeneration REGEN button for several seconds to regenerate the softener manually and have soft

water again.

Your softener can use any kind of salt, including extra coarse softening salt, or pellets. It also works with

potassium chloride, sometimes sold as K Life or Potassium Salt.

Clack WS1 Water Softener Installation Guide