Aquaox C Series Quick Start Manual - Page 6
Browse online or download pdf Quick Start Manual for Control Unit Aquaox C Series. Aquaox C Series 8 pages. Clack head
Print Page11. See the Clack WS1 Service Manual for instructions on how to program and set softener. Your
softener is already programmed for the size tank you have, but you do need to set the current
time of day and program the water softener with your water hardness. When programming
add 2 or 3 grains of hardness to your water hardness as a safety measure if you have iron in the
water.
12. Start a manual backwash by pressing and holding the REGEN button for 5 seconds. After
softener has been regenerating for 20 minutes, look inside the brine tank, and you should see
that is has sucked out the brine. At the end of the regeneration (90 minutes) check to make
sure that the softener has added water to the bottom of the brine tank to make brine for the
next regeneration cycle.
Maintaining Your WS1 Softener System
WS1 Softeners require little maintenance. The primary task is to add salt to the brine tank a couple of
times a year. You can fill the salt tank to the top if wish and then wait until the brine tank is near empty
before adding salt again. Or you can add salt whenever you notice that the salt is low enough to add
more bags. If you fail to add to salt the water will turn hard again, and you will notice that there is
water in the bottom of the brine tank. This is normal, and you can add salt and press the manual
regeneration REGEN button for several seconds to regenerate the softener manually and have soft
water again.
Your softener can use any kind of salt, including extra coarse softening salt, or pellets. It also works with
potassium chloride, sometimes sold as K Life or Potassium Salt.
Clack WS1 Water Softener Installation Guide