AQUAPHOR RO-102S 소유자 매뉴얼 - 페이지 16
{카테고리_이름} AQUAPHOR RO-102S에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AQUAPHOR RO-102S 20 페이지. Reverse osmosis system
AQUAPHOR RO-102S에 대해서도 마찬가지입니다: 소유자 매뉴얼 (16 페이지)
10. Replacing cartridges, Cont.
Replacing the conditioning cartridge K7М (K7*)
Set the shutoff valve on the connection node into the closed position; then open the clean water faucet to
1.
discharge pressure.
Press the button above the cartridge, and then rotate the used conditioning cartridge K7М (K7) in a
2.
clockwise direction to remove it.
Install a new conditioning cartridge.
3.
Set the shutoff valve on the connection node into the open position; then wait for all of the water to flow out
4.
from the storage tank through the clean water faucet.
Then close the clean water faucet.
5.
When the tank is filled, your RO is ready for operation.
6.
Make sure that RO is properly sealed.
7.
Replacing the membrane cartridge
Set the shutoff valve on the connection node into the closed position, and then open the clean water faucet
1.
to discharge pressure.
Press the button above the cartridge, and then rotate the used membrane cartridge in a clockwise direction
2.
to remove it.
Install a new membranecartridge in place of the removed one.
3.
Turn the shutoff valve on the connection node to the open position.
4.
Flush the water through RO for duration of approximately 1 hour.**
5.
Close the clean water faucet.
6.
When the tank is filled, RO is ready for operation.
7.
Make sure that RO is properly sealed.
8.
ATTENTION! To avoid any incorrect installation of the membrane cartridge and the resulting
loss of sealing of the RO connections, it is not recommended to dissemble it without a fully
qualified maintenance specialist. If the RO connections are leaking, immediately close the tap
on the connection unit and check the cartridges for correct installation.
* The K7 cartridge is not included in the water filter set and is sold separately.
** Depending upon storage, transportation and operation conditions, complete flushing of the membrane cartridge may take
up to 24 hours.
16
AQUAPHOR RO-101S, RO-102S