AquaPix W5012 Splash 매뉴얼 - 페이지 3
{카테고리_이름} AquaPix W5012 Splash에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AquaPix W5012 Splash 3 페이지.
페이지 인쇄
8. System requirement
Operating system
Win XP, Vista, Win7, Win8, Win10, Mac OSX 10.6.8 or above
CPU
Pentium 4 / 3.0G or faster recommended
RAM
1 GB MB RAM (Vista: 2 GB)
Interface
USB port
CD
CD ROM Driver
9. Troubleshooting
Problem
Cause
Cannot turn on the camera
Low battery power.
Battery placed at wrong
polarities.
Photos can not be saved
The memory card hasn't
when taking pictures.
been formatted properly.
Cannot find removable disk
Connection failure.
after connecting the
.
camera to the computer
Flash does not work.
Battery power is too low.
The batteries used up very
Incorrect or old, used up,
fast.
battery
The photos are blurry
1. The camera is not held
steadily
2. The lens of camera is
dirty.
HOW TO OPEN THE BATTERY
COMPARTMENT OF THE CAMERA
Push the release lever toward the rear of the camera.
At the same time place your fingernail under the cover in the middle of the camera and slide the
compartment to the outside.
The battery compartment cover can now be hinged upward.
DECLARATION OF CONFORMITY
easypix herebly declares that the product W5012 is in conformity to all the
essential requirements of Directive 1999/5/EC. The declaration of conformity can be downloaded here:
http://www.easypix.info/download/pdf/doc_w5012.pdf
For technical support please visit www.easypix.eu.
Only EU
Solution
Replace or install the battery
correctly.
Format the memory in setup
mode of the camera. Please
refer to section 5.3.
Make sure all cable connections
are secured and restart the
computer if necessary.
Replace with new 2 x AAA
alkaline batteries
Replace with 2 x AAA alkaline
batteries
1. Hold the camera steadily
when taking video or photo.
2. Clean the lens with soft dry
cloth.