BURL B80-BMB3 MOTHERSHIP 빠른 시작 매뉴얼 - 페이지 8

{카테고리_이름} BURL B80-BMB3 MOTHERSHIP에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. BURL B80-BMB3 MOTHERSHIP 15 페이지. Bmb3 rev c rom 1

2.5 Set BMB3 Front Panel to INT, EXT, or DANTE

Image 9: BMB3 Front panel. Set Clock Control to INT, EXT, or DANTE

•

When using the B80 on internal clock, set to INT.

•

If using external word clock, set to EXT.

•

When clocking off Dante network, set to DANTE.

For a complete guide to Dante Clocking, see page 12.

2.6 Connect The Computer's Native Ethernet Port To Gigabit

Ethernet Switch

Even when using a Dante PCIe Card, Dante Controller requires a native Ethernet port and will

not work via the PCIe Card.

2.7 If Using A PCIe Card, Connect Primary Port Of PCIe Card

To Gigabit Ethernet Switch

When using a Dante PCIe Card, audio is transmitted via the PCIe card.

2.8 For INT, Set BMB3 To Desired Sample Rate

Push the "Sample Rate" button on BMB3 faceplate to toggle through sample rates. When set

to INT, BMB3 must always be manually set to the desired sample rate. When using EXT or

DANTE clock, the MOTHERSHIP will not need to be manually set via the front panel.

2.9 For Dante Virtual Soundcard (DVS), Open And Run DVS

2.10 Open "Dante Controller"

SECTION 2