Aquaport DELUXE AQP-WCM 매뉴얼 - 페이지 7

{카테고리_이름} Aquaport DELUXE AQP-WCM에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquaport DELUXE AQP-WCM 12 페이지. Executive water cooler, cold and room

2. To remove the bottle supporter there is an arrow and the

word "OPEN" embossed into the bottle support. Line this up

with the small sticker found on the top panel of the water

cooler that also has an arrow the word "OPEN". Then grab

the bottle supporter by placing your fingers under the rim and

vertically pull off.

3. When the bottle support is removed you should be able to

see inside the stainless steel cooling tank.

4. Follow the instructions that come with the filter bottle for

correct installation.

5. Place the filter bottle on top of the water cooler and fill as per

the instruction in the filter bottle user manual.

Note: Filter bottles generally have a

slower flow rate compared to spring

Fig 1

water bottles, hence it will take longer

to fill the cooling tank. Allow the

cold tank to fill for 30 minutes before

following Steps 2-5 as explained in

section A) Executive water cooler

Installation for Spring Water bottles.

C. Product Use

Always closely supervise children around this appliance.

If the supply cord is damaged, it must be replaced by the

manufacturer, its service agent or similarly qualified persons in

order to avoid a hazard.

The Aquaport Executive water cooler has been rated to provide

a limited number of servings per hour. On average you should be

able to receive 2-4L of cold water within 1hour. Higher ambient

temperature will affect its performance.

The thermostat has been set by the manufacturer and does not

need to be adjusted. Do not adjust the thermostat unless advised

by Aquaport. Unauthorised adjustment or modification to the unit

will void the warranty.

Do not hesitate to contact our Customer Care Service line on

INSTALLATION AND OPERATING INSTRUCTIONS 5