Aquaport AQP-FKL-C 사용자 설명서 - 페이지 6

{카테고리_이름} Aquaport AQP-FKL-C에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquaport AQP-FKL-C 16 페이지. The caravan/marine water filtration system

B. WATER SUPPLY INSTALLATION

Preferred Installation

Typical installation utilising existing water supply and flexible cold

water hose is shown on Page 3.

Note: Plumbing connections may vary, please consult a qualified

installer for correct installation.

1. Locate cold tap water pipe and turn water supply off at the

isolation tap. If no isolation tap is available, turn water off at

the source. Turn on tap at sink to ensure water is turned off

and to drain the pipe.

2. Remove the flexible cold water hose that connects the cold

water faucet to the mains cold water outlet. Some water may

spill out.

3. Wrap sealing tape (8) around cold water outlet in a

clockwise direction.

Note: Do not apply sealing tape (8) in a counter clockwise

direction, it releases the tape and leaks may occur.

4. Hand tighten the mains connection piece (6) to the mains

cold water outlet (please see Fig 1). Finish tightening with an

adjustable wrench. Be careful not to over tighten, as cross

threading and leaking can occur.

4 INSTALLATION AND OPERATING INSTRUCTIONS

5. Wrap sealing tape around male thread of mains connection (6)

in a clockwise direction and reconnect the flexible cold water

hose to it.

6. Wrap sealing tape around male thread of shut off valve (7) in

a clockwise direction and hand tighten the shut off valve (7) to

the mains connection piece (6). Fig 1. Make sure shut off valve

is not against a wall as the 1/4" tubing must not be bent.

7. Install 1/4" tubing (3). (see tubing installation section E)

Fig 1

Flexible

Cold

Water

Tap

Hose

1/4" Tubing

to filtration kit

Mains Cold

Water Isolation

Outlet