Aquaport AQP-FKL-C Kullanıcı Kılavuzu - Sayfa 6
Su Filtrasyon Sistemleri Aquaport AQP-FKL-C için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Aquaport AQP-FKL-C 16 sayfaları. The caravan/marine water filtration system
Sayfayı YazdırB. WATER SUPPLY INSTALLATION
Preferred Installation
Typical installation utilising existing water supply and flexible cold
water hose is shown on Page 3.
Note: Plumbing connections may vary, please consult a qualified
installer for correct installation.
1. Locate cold tap water pipe and turn water supply off at the
isolation tap. If no isolation tap is available, turn water off at
the source. Turn on tap at sink to ensure water is turned off
and to drain the pipe.
2. Remove the flexible cold water hose that connects the cold
water faucet to the mains cold water outlet. Some water may
spill out.
3. Wrap sealing tape (8) around cold water outlet in a
clockwise direction.
Note: Do not apply sealing tape (8) in a counter clockwise
direction, it releases the tape and leaks may occur.
4. Hand tighten the mains connection piece (6) to the mains
cold water outlet (please see Fig 1). Finish tightening with an
adjustable wrench. Be careful not to over tighten, as cross
threading and leaking can occur.
4 INSTALLATION AND OPERATING INSTRUCTIONS
5. Wrap sealing tape around male thread of mains connection (6)
in a clockwise direction and reconnect the flexible cold water
hose to it.
6. Wrap sealing tape around male thread of shut off valve (7) in
a clockwise direction and hand tighten the shut off valve (7) to
the mains connection piece (6). Fig 1. Make sure shut off valve
is not against a wall as the 1/4" tubing must not be bent.
7. Install 1/4" tubing (3). (see tubing installation section E)
Fig 1
Flexible
Cold
Water
Tap
Hose
1/4" Tubing
to filtration kit
Mains Cold
Water Isolation
Outlet