Aquaproducts UltraMAX 운영자 매뉴얼 - 페이지 6

{카테고리_이름} Aquaproducts UltraMAX에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquaproducts UltraMAX 11 페이지. Commercial swimming pool cleaners

페이지 인쇄

PROBLEM

7 The Infrared Sensor is not working

(The Cleaner is not sensing walls and

Reversing direction)

8 The Cleaner consistently pulls to the

left or right

Handle

Rope

Locator

Block

Because of the angles of your pool's bottom and sides, the

Infrared Eye (Sensor) may not be "seeing" the wall or obstacle in time

to reverse the Cleaner's direction and may require adjustment.

a) To adjust the sensor loosen the two Screws on the Sensor

Bracket. These Screws are located by the Infrared

Sensor on the side of the Cleaner.

b) Move or adjust the Sensor to the desired position.

c) Tighten the Screws again so the Sensor will not move.

If the Infrared Sensor does not operate properly, it is not

always the fault of the Infrared Eye, but rather maybe is the fault of

the Drive Motor electronics.

a) Remove the Cleaner form the water and place it in a

horizontal position.

b) Remove the external Infrared "eye" but don't disconnect it.

Then, put your hand in front of the "eye" if the Cleaner

reverses, the "eye" is working. If no, contact Aqua Products

Tech Support for assistance: (888)AQUATECH/278-2832

or e-mail [email protected]

* The Infrared Sensor is an option installed at the time of

manufacture and can not be added afterwards.

The standard Cleaner model has the Cable Assembly installed in the

middle of the Cleaner with the help of a rope and a metal Locator

Block.

If the Cleaner circles (turns) to the left or to the right when it cleans

during automatic programming (not with Remote Control) please

check and adjust:

a) That the Cable Assembly is spread out and untangled.

b) If step (a) was done and the Cleaner still turns (too

much), loosen the Screw in the center of the Locator Block

and slide the Cable Assembly to the side opposite of the

direction in which the Cleaner is turning.

Example: If the Cleaner is turning to the right, slide the Cable

sembly with the Rope to the left side. Then re-tighten the Screw in

the Locator Block to secure the Rope and the cable Assembly in this

new position.

Cable

Assembly

THINGS TO CHECK

As-