Aquaproducts UltraMAX Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Środki do czyszczenia basenów Aquaproducts UltraMAX. Aquaproducts UltraMAX 11 stron. Commercial swimming pool cleaners

Aquaproducts UltraMAX Instrukcja obsługi
PROBLEM
7 The Infrared Sensor is not working
(The Cleaner is not sensing walls and
Reversing direction)
8 The Cleaner consistently pulls to the
left or right
Handle
Rope
Locator
Block
Because of the angles of your pool's bottom and sides, the
Infrared Eye (Sensor) may not be "seeing" the wall or obstacle in time
to reverse the Cleaner's direction and may require adjustment.
a) To adjust the sensor loosen the two Screws on the Sensor
Bracket. These Screws are located by the Infrared
Sensor on the side of the Cleaner.
b) Move or adjust the Sensor to the desired position.
c) Tighten the Screws again so the Sensor will not move.
If the Infrared Sensor does not operate properly, it is not
always the fault of the Infrared Eye, but rather maybe is the fault of
the Drive Motor electronics.
a) Remove the Cleaner form the water and place it in a
horizontal position.
b) Remove the external Infrared "eye" but don't disconnect it.
Then, put your hand in front of the "eye" if the Cleaner
reverses, the "eye" is working. If no, contact Aqua Products
Tech Support for assistance: (888)AQUATECH/278-2832
* The Infrared Sensor is an option installed at the time of
manufacture and can not be added afterwards.
The standard Cleaner model has the Cable Assembly installed in the
middle of the Cleaner with the help of a rope and a metal Locator
Block.
If the Cleaner circles (turns) to the left or to the right when it cleans
during automatic programming (not with Remote Control) please
check and adjust:
a) That the Cable Assembly is spread out and untangled.
b) If step (a) was done and the Cleaner still turns (too
much), loosen the Screw in the center of the Locator Block
and slide the Cable Assembly to the side opposite of the
direction in which the Cleaner is turning.
Example: If the Cleaner is turning to the right, slide the Cable
sembly with the Rope to the left side. Then re-tighten the Screw in
the Locator Block to secure the Rope and the cable Assembly in this
new position.
Cable
Assembly
THINGS TO CHECK
As-