Burmester Classic Series 소유자 매뉴얼 - 페이지 7
{카테고리_이름} Burmester Classic Series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Burmester Classic Series 12 페이지. Integrated amplifier
Burmester Classic Series에 대해서도 마찬가지입니다: 소유자 매뉴얼 (16 페이지)
페이지 인쇄
OPERATING THE AMPLIFIER
AC mains switch
The AC mains switch (7) is located at the rear of the housing. It disconnects the 956 MK 2 from the AC
supply. When it is set to OFF the unit is completely disconnected, the LEDs on the front panel remain dark.
Switching to ON activates the stand - by mode and the left STAND BY- LED (1) on the front panel illuminates.
POWER - button
The POWER - button (2) on the front panel switches the 956 MK 2 into operating mode or back into
stand - by mode. In operating mode STAND BY - LED (1) and POWER LED (3) are illuminated. In
stand - by mode only STAND BY - LED (1) lights up. After switching to operating mode the monitoring
system of the 956 MK 2 takes a few seconds to check all circuits before enabeling the speaker outputs.
HOOK - UP OPTIONS
STEREO operation
To use the 956 MK 2 in STEREO mode make the following connections:
(12)
(10)
(11)
MONO operation
To use the 956 MK 2 in MONO moder make the following connections:
(12)
(10)
(11)
BI - AMPING
To use the 956 MK 2 in BI - AMPING mode make the following connections:
(12)
(10)
(11)
(4)
input right channel
(6)
speaker terminal right channel positive
(5)
speaker terminal right channel negative
input left channel
speaker terminal left channel positive
speaker terminal left channel negative
(4)
MONO - ADAPTER (14), red marking
(6)
speaker terminal positive
(5)
must not be connected
MONO - ADAPTER (14), blue marking
speaker terminal negative
must not be connected
(4)
BI - AMP - ADAPTER (15), red marking
(6)
speaker terminal positive for mid- to high-range drivers
(5)
speaker terminal negative for mid- to high-range drivers
BI - AMP- ADAPTER (15), blue marking
speaker terminal positive for bass driver
speaker terminal negative for bass driver
6