Aquasana AQ-5200.56 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Aquasana AQ-5200.56에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquasana AQ-5200.56 9 페이지. Under sink

INSTALLATION STEPS

Assemble Dedicated Faucet

A. Slide rubber washer onto dedicated

faucet and insert into drilled hole.

B. From underneath the sink, slide

faucet spacer onto dedicated faucet.

C. Slide lock washer onto dedicated

faucet.

D. Tighten faucet nut to secure faucet

to sink.

Connect Dedicated Faucet

A. Slide the chrome nut onto the

poly tubing, followed by the

white plastic collar.

B. Press the plastic tube insert into

the end of the poly tubing.

C. Press the poly tubing against

the faucet base, and slide the

chrome nut and plastic collar up

to the threads of the faucet. Use

wrench to tighten.

NOTE: DO NOT over tighten.

Install System Manifold

A. Select a location under the sink that is at

least 12" from the bottom of the cabinet.

B. Use mounting holes located on the back

of the system manifold to mark wall

screw placements with pencil.

AQ-5200: 65mm • AQ-5300: 98mm • AQ-5300+: 99mm

C. Use a 7/32" drill bit to drill holes for plastic anchors. Carefully tap the

plastic anchors into the drilled hole with hammer.

D. Mount system manifold to the wall with screws.

E. Pull the protective plastic strip from battery compartment. LED will flash

red and beep 5 times to indicate correct battery installation.

INSTALLATION STEPS

NOTE: Select a location

that allows easy access

to cold water supply and

filter replacing.

12" min