Aquasana AQ-UV-L330C 소유자 매뉴얼 - 페이지 12

{카테고리_이름} Aquasana AQ-UV-L330C에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquasana AQ-UV-L330C 20 페이지. Whole house uv filter

Aquasana AQ-UV-L330C 소유자 매뉴얼
INSTALLATION STEPS
10
9
Insert UV Lamp
Always hold UV Lamps by their ceramic ends, not by
the Lamp bulb. Again, use cotton gloves for this step.
Remove the UV Lamp from its packaging.
Insert the UV Lamp into the UV Reactor.
NOTE: DO NOT touch the key's exposed contacts.
UV Lamp Connection
10
1. Plug the UV Lamp Connector
into the UV Lamp. Note the
keying for proper alignment.
2. Insert the UV Lamp Connector
into the Gland Nut and turn
the connector approximately
¼ turn to lock the Connector
to the Gland Nut.
11
Ground Screw Connection
Tighten the captive ground screw to
the ground lug on the UV Reactor using
a Phillips Head Screwdriver to ensure
proper grounding as shown.
Plug-In UV Filter
12
Your system is now ready to be plugged into the appropriate GFCI
protected outlet. Refer to the following System Disinfection section
before any water is allowed to flow through the system.
WARNING
1
2