Aquasana AQ-UV-L420C 소유자 매뉴얼 - 페이지 10

{카테고리_이름} Aquasana AQ-UV-L420C에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquasana AQ-UV-L420C 20 페이지. Whole house uv filter

INSTALLATION STEPS

Plumb In UV Filter

1. Use the Mounting Brackets to mount the UV Reactor to wood

or drywall. If mounting to an alternate material, you will need

to purchase the proper corresponding fasteners.

2. Plumb UV Filter and additional filtration add-ons into the

system at this time. Screw Post-Filter support brackets onto

the wall and attach filter. Use PVC pipe, elbows and reducers

to connect from Post-Filter to UV inlet.

3. Properly connect system together accordingly (slip fittings,

barbed fittings, NSF certified PVC glue, etc.). Ensure all parts

are flowing through in the correct direction of water flow.

4. Once installation is complete, allow proper time for glue

to dry according to manufacturer instructions.

Insert the Quartz Sleeve

DO NOT touch the Quartz Sleeve with your hands. Use

cotton gloves for this procedure as oils from hands can

leave residue on sleeve and UV Lamp blocking UV light.

1. Gently remove the Quartz Sleeve from packaging

and slide the sleeve into the UV Reactor. Align

the Quartz Sleeve so it's centered and gently

push it in to lock it into the internal centering

springs on the opposite end of the UV Reactor.

NOTE: Pushing too hard when the Quartz Sleeve is

not aligned can damage the Centering Springs.

2. Slide the O-Ring onto the Quartz Sleeve until

it is butted up against the UV Reactor.

WARNING