Panasonic AG-AC130A Series 매뉴얼 - 페이지 8
{카테고리_이름} Panasonic AG-AC130A Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic AG-AC130A Series 18 페이지. Broadcast-grade camera recorder with 22x zoom lens and 2.2 megapixel u.l.t. image sensor
Panasonic AG-AC130A Series에 대해서도 마찬가지입니다: 사용 설명서 (38 페이지), 브로셔 (12 페이지), 빠른 매뉴얼 (1 페이지)
페이지 인쇄
External Microphones
While the camcorder has a built-in microphone, using an external microphone allows you to place
the mic much closer to the sound source and get better sound. The closer the microphone is to the
sound source, the better the sound will be recorded.
We have several types of external microphones: clip-on (lavaliere) and handheld.
Usually, the clip-on mic is used for interviews. It should be clipped onto a lapel or
shirt placket no more than 10" below the chin, and made to look as inconspicuous
as possible by running the wire underneath clothing.
Since it runs on a battery, the power must be switched
on at the belt pack.
The handheld mic is a good all-purpose mic to use for news conferences,
standups, meetings, musical events, etc. With no battery inside, the
handheld mic is ready to use as soon as it's plugged in. Both microphones
have windscreens that can be used to filter unwanted wind noise or strong
breaths.
Connecting microphones to the camera
6
1. Use an XLR cable to connect the microphone to the AUDIO
INPUT1/2 XLR 3-pin terminals.
2. Switch the connected audio input signal with the INPUT1
LINE/MIC switch or INPUT2 LINE/MIC switch.
Use <MIC> when connecting either kind of wired microphone
or wireless handheld;
Use <LINE> when connecting to a wireless clip-on or any
mixing board/PA sound system.
3. Use the AUDIO CH1 SELECT switch to select the input signal
to be recorded to audio channel 1.
<INT (L)>: audio from the built-in microphone Lch is recorded.
<INPUT1>: Audio from the device connected to AUDIO
INPUT1 terminal is recorded.
<INPUT2>: Audio from the device connected to AUDIO
INPUT2 terminal is recorded.
4. Use the AUDIO CH2 SELECT switch to select the input signal
to be recorded to audio channel 2.
<INT (R)>: Audio from the built-in microphone Rch is recorded.
<INPUT2>: Audio from the device connected to AUDIO
INPUT2 terminal is recorded.