Panasonic AG-AC160A Series 단계별 매뉴얼 - 페이지 3

{카테고리_이름} Panasonic AG-AC160A Series에 대한 단계별 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic AG-AC160A Series 8 페이지. Broadcast-grade camera recorder with 22x zoom lens and 2.2 megapixel u.l.t. image sensor
Panasonic AG-AC160A Series에 대해서도 마찬가지입니다: 브로셔 (12 페이지), 사용 설명서 (42 페이지), 빠른 매뉴얼 (1 페이지)

페이지 인쇄

Step-by-Step Shooting Guide

Power Up, Set to P2 Camera Mode:

1) Make sure the Power Switch is OFF

If it was left on, push in the little white

button and rotate it to OFF

2) Slide a battery into the slot on the rear

surface of the camera. Push it in near the

top of the opening, and slide it down until it

locks into place.

The arrow on the battery label should be

point down when in position.

NOTE! There are 2 larger batteries,

and 1 smaller battery with each cam-

era. The large batteries should last for

at least 4 hours, the small for about 3.

3) Slide the AC power adaptor into the same

slot. The other end of the cable connects to

the jack on the front of the adaptor.

4) Turn on the POWER.

Remember, push in the little white button to

rotate the switch to the ON position.

Charging Batteries

5) If not using the AC power adaptor to power

the camera, you can use it to recharge the

batteries.

The battery slides onto the slot on the top

of the AC Power Supply box.

The CHARGE light will come on while

charging, and go out when finished. Each

battery will require up to 4 hours to fully

recharge if completely drained.

NOTE: You can't charge a battery at the same

time you are using the adaptor as a power

supply! You should completely unplug both

ends of the cable that runs from the camera to

the AC power supply box when charging.

Pg. 3