AquaScape Economy Foam Gun Applicator 설치 지침 및 유지 관리 - 페이지 2

{카테고리_이름} AquaScape Economy Foam Gun Applicator에 대한 설치 지침 및 유지 관리을 온라인으로 검색하거나 PDF를 다운로드하세요. AquaScape Economy Foam Gun Applicator 2 페이지.

Instructions

STEP 1

• Before putting a can of foam on the gun, press the trigger

down to release any air trapped in the barrel.

STEP 2

• Shake foam can and thread the can into the gun.

NOTE: do not overtighten.

STEP 3

• Squeeze trigger to allow foam to fill the barrel.

STEP 4

• Adjust the flow by tightening or loosening the flow-

adjustment screw found on the back of the gun.

STEP 5

• For best results, mist the area to be foamed with water first.

STEP 6

• When finished, tighten the flow-adjustment screw fully until

trigger is locked.

General Maintenance

• Nozzle tip can be cleaned using a wire brush or similar

material. DO NOT scrape on rough surface such as

concrete or rocks.

• If the gun barrel is clogged, use a can of Foam Gun Cleaner

(Item #22011) to flush out the barrel.

• If the ball valve, located in the gun where the can is

attached, becomes stuck, use a thin object such as a

pencil, to press down on the ball to release.

WARNING: Always keep a can of

foam on the gun. Failure to do so

will cause foam to harden in the

barrel and clog the gun.

For more information about our company or products, please visit our website at aquascapeinc.com

04/18

or call us at US (866) 877-6637or CAN (866) 766-3426

☎

US (866)877-6637 |

☎

CAN (866)766-3426 | aquascapeinc.com