AquaScape Economy Foam Gun Applicator Installation Instructions & Maintenance - Page 2
Browse online or download pdf Installation Instructions & Maintenance for Outdoor Fountain AquaScape Economy Foam Gun Applicator. AquaScape Economy Foam Gun Applicator 2 pages.
Instructions
STEP 1
• Before putting a can of foam on the gun, press the trigger
down to release any air trapped in the barrel.
STEP 2
• Shake foam can and thread the can into the gun.
NOTE: do not overtighten.
STEP 3
• Squeeze trigger to allow foam to fill the barrel.
STEP 4
• Adjust the flow by tightening or loosening the flow-
adjustment screw found on the back of the gun.
STEP 5
• For best results, mist the area to be foamed with water first.
STEP 6
• When finished, tighten the flow-adjustment screw fully until
trigger is locked.
General Maintenance
• Nozzle tip can be cleaned using a wire brush or similar
material. DO NOT scrape on rough surface such as
concrete or rocks.
• If the gun barrel is clogged, use a can of Foam Gun Cleaner
(Item #22011) to flush out the barrel.
• If the ball valve, located in the gun where the can is
attached, becomes stuck, use a thin object such as a
pencil, to press down on the ball to release.
WARNING: Always keep a can of
foam on the gun. Failure to do so
will cause foam to harden in the
barrel and clog the gun.
For more information about our company or products, please visit our website at aquascapeinc.com
04/18
or call us at US (866) 877-6637or CAN (866) 766-3426
©2018 Aquascape, Inc. • All Worldwide Rights Reserved
☎
US (866)877-6637 |
☎
CAN (866)766-3426 | aquascapeinc.com