Diamond DRCS-24 설치 및 운영 매뉴얼 - 페이지 8
{카테고리_이름} Diamond DRCS-24에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamond DRCS-24 11 페이지. Carving station
페이지 인쇄
The Carving Station power for the top ceramic heat and
the incandescent lights are controlled by the on/off
toggle switch. The switch must be in the "ON" position
for the unit to function. To control the top heat, set the
infinite switch to the desired heating level.
For models with heat in the base, power is
independently controlled by the on/off rocker switch.
Set base control thermostat to the desired heating level
as indicated on the control plate.
WARNING
Some exterior surfaces on the Carving Station will
get hot. Use caution when touching these areas to
avoid injury.
Base Control
Thermostat
Figure 5. Controls
5
OPERATION
Heat Control Infinite Switch
On/Off Toggle Switch
On/Off Rocker Switch
Form No. GRCSM-0401