CHT Spectra 25 매뉴얼 및 설치 매뉴얼 - 페이지 10

{카테고리_이름} CHT Spectra 25에 대한 매뉴얼 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CHT Spectra 25 16 페이지. Water stove

5.1) Standards

• Heating System – during installation and operation of the boiler it is very

important to keep safe distance from the inflammable materials. The boiler

is allowed to work only in open type heating systems!

• Electrical installation – the regulator's power supply is 230V/50Hz

• Chimney – It must be done with respect to current norms and regulations.

Due boiler gasses temperature 90-100 C it is obligatory to put the INOX

or other material tubes into the chimney. Required chimney draught is

0,1 – 0,2 mbar. Installation according to ADJ does entail some testing of

the chimney, which may be carried out by a sweep

• Important sources of guidance installers: 98/37/EEG; 89/336/EEG;

73/23/EEG; EN 55014-1, 1993 /A1, 1997; EN 55014-1; EN 55014-2 C1

1998; EN 61000-3-2; EN 61000-4-2, -3-4-5-6-11, Level2; EN 50165; EN

50165 C1; EN 60335-1; EN 303-5; EN 12809; EN 13394

5.2) Combustion ducts, ventilation:

connecting

recommendations:

To provide the correct work of device the chimney draught should figure

out about 15 Pa.

The flue should be performed from heat-resistant steel and leaded

straight as possible and with the smallest number of deflecting.

Connecting flue with chimney should be made at an angle of 45º.

The assembly of simple section after exit from flue connection courts

about length min. 30 cm directly.

The connections of flue should be tight.

Fireplace should be connected to individual flue.

External chimneys should be insulated.

Room in which fireplace will be installed should be equipped in

ventilations.

The minimum intersection of chimney is 400 cm2 and height this 6-8 m.

Air to fireplace should be brought by channel about intersection

=100mm

- 10 -

fireplace

flue

should

turn

attention

following