Aquascape Pro 7500 설치 및 유지 관리 지침 매뉴얼 - 페이지 4

{카테고리_이름} Aquascape Pro 7500에 대한 설치 및 유지 관리 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquascape Pro 7500 16 페이지.

Check Valve:

With the skimmer properly installed in ground, feed flex PVC discharge pipe leading to the

BioFalls

through hole in back of skimmer (see Fig.1 on page 5). Slide collar piece over PVC

FIRST, then glue pipe end cap to PVC tubing (see fig. 2 on page 5). The fitting on the bottom

of the Aquascape check valve assembly should be threaded into the pump discharge. Stand-

ing behind the Skimmer set the pump along the right side, inside the skimmer vault (see Fig.

3 on page 6). Connect the check valve assembly by sliding the collar up to the check valve

and tightening (see Fig. 4 on page 6)*.

*See installation instructions for other aspects of pump and pond maintenance.

Submergence:

It is recommended that the pump be operated in the submerged condition. The pump is

equipped with a thermal protector which will shut down the pump temporarily in low water

conditions. However, this is not recommended for extended periods of time.

Discharge:

An Aquascape check valve is recommended for each pump being used. The Aquascape check

valve is used to prevent backflow into the sump. Excessive backflow can cause flooding

and/or damage to the pump.

The Aquascape Ecosystem

The Aquascape Skimmer

sweeps the pond surface,

prevents the pump from

clogging, and hides

everything!

A rock lid hides

the skimmer.

Flexible PVC piping runs

alongside the pond and

makes pluming easy.

Eliminate unsightly plant pots by

digging a plant pocket and filling it

with soil and cat liter.