Chubbsafes PRIMUS / E-LOCK PS600 사용 설명서 - 페이지 3
{카테고리_이름} Chubbsafes PRIMUS / E-LOCK PS600에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Chubbsafes PRIMUS / E-LOCK PS600 7 페이지. With electronic lock For more information, please visit www.chubbsafes.com
페이지 인쇄
1. OPENING THE LOCK.
1.1 Opening using the user code or the master code
- Press«ON» – single acoustic signal and green LED;
- Enter master or user code, consisting of 6...8 symbols (master code set up in the factory, 1-2-3-4-5-6,
the user code is not activated);
- Press«ENTER». After the green LED is activated the lock is ready to open during 5 seconds.
1.2 Opening using a second code (this functionnality is valid when the user
code and the master code are active.
1.2.1 Activate the functionnality
- Press "ON"
- Press "ENTER";
- Press "7";
- Press "ENTER" (if the user code has not been activated the lock will be deactivated after a Bip and red
LED);
- Enter the master code and press and press "ENTER";
1.2.2 Opening of the lock
- Press "ON"
- Enter the master code and press and press "ENTER";
- Within 60 secondes enter the user code and press "ENTER" until the green LED.
1.2.3 Desabling of the functionnality
- Press "ON"
- Press "ENTER"
- Press "8"
- Press "ENTER"
- Enter the master code and press "ENTER"
Should the master code or the user code wrong or the user code not set yet, the lock will be deactivated
after a Bip and the red LED.
Should an incorrect master or user code be entered 3 times, then the lock will be locked outfor 5
minutes after a Bip and red LED.
Ref OP-0012-A April 2015
Page 3