Diamond Antenna SG-M510 매뉴얼

{카테고리_이름} Diamond Antenna SG-M510에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamond Antenna SG-M510 2 페이지. 2m/70cm dual-band mobile antenna
Diamond Antenna SG-M510에 대해서도 마찬가지입니다: 어셈블리 (2 페이지)

페이지 인쇄

FREQUENCY:

GAIN :

POWER :

ELEMENT PHASING : 2m: 1/2l, 70cm: 2 5/8l

IMPEDANCE :

LENGTH :

WEIGHT :

MOUNT :

WARRANTY :

Recommended Mounts: Any Diamond K-Series mount with UHF base connector.

1. Remove antenna from package and inspect contents to insure it is complete.

2. Choose desired mounting location to insure maximum strength of mount, and best performance of antenna.

3. Install antenna on vehicle. With quality VSWR meter, check VSWR. The SG-M510 is pre-tuned and should not require

any additional tuning.

4. Tighten setscrews. Recommend using removable Loctite Threadlocker #242 or similar product on setscrews.

Lift upper half of foldover hinge vertically out of its conical socket, avoiding the use of the sockets' edge as a fulcrum.

Position hinge to permit foldover in desired direction. Care should be taken when folding over, not to damage vehicle

or antenna. Do not drive with antenna in folded position.

PFP 'XDO%DQG 0RELOH $QWHQQD

2m: 144-148 MHz, 70cm: 440-450 MHz

2m: 2.15 dBi, 70cm: 5.5 dBi

100 Watts

50 Ohms (nominal)VSWR : 1.5:1 (nominal)

37"

.3 lbs.

UHF Male

1 year against defects in material or workmanship.

Foldover Hinge Assembly

',$021' $17(11$ 3URGXFWV DUH GLVWULEXWHG E\ 5) 3$576 &203$1<

6 3DFLILF 6WUHHW 6DQ 0DUFRV &$

ZZZGLDPRQGDQWHQQDQHW

SG-M510

Specifications

Antenna Assembly