AquaStar StarzTruck 설치 매뉴얼 - 페이지 13
{카테고리_이름} AquaStar StarzTruck에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AquaStar StarzTruck 20 페이지. Automatic suction pool cleaner
페이지 인쇄starztruck automatic pool cleaner troubleshootinG Guide
problem: cleaner climbs to surface and sucks air
CAUSES
Too much/improper water flow through cleaner
Improper tension on rear flap
Steering failure
problem: cleaner head floats
CAUSES
Cleaner head or return line has air in it
The cleaner head is being pulled or lifted off
the bottom of the pool by the cleaner hose or
return line flow – either at the surface or at the
bottom of the pool – or both
SOLUTIONS
Adjust water flow per step 3, Fig. 7
Turn rear flap adjuster to I
If still climbing too much, reduce water flow
until proper operation is achieved
1. Check and clean rear screen
2. Check to see that cone gear is free and
rotates smoothly in both directions
3. Check medium turbine and spindle gear
assemblies for malfunction
SOLUTIONS
Remove all air from cleaner head
Stop all air from entering the pool through
the return lines
If cleaner head and hose are covered with fine
bubbles, give the hose a good tug. This will release
the air bubbles and allow the cleaner head to settle
to the bottom of the pool until the hose is covered
with bubbles again
Readjust return lines to prevent water flow from
interfering with cleaner head and/or hose
11