AQUASTREAM ABSC02782 설치, 운영 및 유지보수 매뉴얼 - 페이지 14

{카테고리_이름} AQUASTREAM ABSC02782에 대한 설치, 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AQUASTREAM ABSC02782 20 페이지.

페이지 인쇄

Step 1

5/8

67 mm

1 "

25 mm

Step 2

Step 4

Back of Control

Step 6

Wall

Step 7

1 "

25 mm

Wall

Adhesive tape

Keypad

Wall

Residential Steambath Generator Systems

Installating the In-Shower Control

Turn power to the steam generator OFF before

IMPORTANT:

installing the control. Failure to turn the power offwill result in an

inoperable control.

Step 1

Determine the desired installation location of the control.

aq uas te am

The

control is designed to be installed inside or out-

side the steam room as a matter of personal preference.

The control cable length is 30 ft. (9 m) Insure that the

control and/or steam generator are located accordingly.

Do not oversize or undersize the hole.

IMPORTANT:

Step 2

R oute the control cable to the steam generator. Connect the connec-

tor to the steam generator.

The connector is keyed

Note:

Do not strain, staple, pinch or otherwise damage

IMPORTANT:

the control cable. R oute cable as required to permit replacement.

Step 3

Turn on power to the steam generator and test the control to verify

correct connections. Test per the instructions. Proceed with installa-

tion and verification of proper control function.

Turn power to the steam generator OFF before

IMPORTANT:

installing the control. Failure to turn the power offwill result in an

inoperable control.

Step 4

R emove & discard peel-offpaper to expose adhesive liner as shown.

Step 5

R un a bead of silicone (provided) as shown around the edge of the

hole.

Do not apply excessive amounts of silicone. Do not

IMPORTANT:

apply silicone to any other parts of the control including the adhe-

sive gasket.

Step 6

Insure the mounting surface is clean and dry as required for good

adhesion. Apply silicone into the hole in the wall as required to cre-

ate a moisture seal. The holder plate may be used to secure the

control if the back of the wall can be accessed.

Step 7

Hold the control and press the control against the wall until the

adhesive sticks and holds firmly as shown.

aquabrass.com