Aquasub engineering AQUA GROUP AQUATEX AV Series 운영 매뉴얼 - 페이지 5

{카테고리_이름} Aquasub engineering AQUA GROUP AQUATEX AV Series에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquasub engineering AQUA GROUP AQUATEX AV Series 15 페이지.

페이지 인쇄

Inspect the purchased pump for damage or leakage during

transportation. And make sure all bolts and nuts are tightened

properly.

A typical installation diagram is shown below. Please

follow the given installation precautions before and during

installation.

Pump should be positioned as shown in figure-A. Pump

should be installed in a protected environment, not

exposed to weather. Provide sufficient space around the

pump for motor cooling and accessibility, refer figure-B.

No.

Pipe support: Support piping system properly to avoid stresses on connections.

Isolating valves: Install isolating valves for easy access- before the pump intake and after

the pump discharge.

Use flexible piping on both input and output sides of the pump to reduce vibration and

transmission of noise.

Check valves will prevent return flow of pumped liquid when pump is stopped, reducing

the danger of pump damage.

Control Panel: Use high quality components. Make sure that the panel conforms to local

standards and regulations.

Do not place elbows next to the pump intake and discharge.

If pump needs to be operated with isolating valve closed, install a by-pass line to avoid

damaging the pumping system.

INSTALLATION PRECAUTIONS

PRODUCT INSPECTION

TYPICAL INSTALLATION

Description