Diamond Audio Technology HP650 설치 매뉴얼 - 페이지 5

{카테고리_이름} Diamond Audio Technology HP650에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamond Audio Technology HP650 8 페이지. Hex pro series 6.5” component system

페이지 인쇄

6.5" COMPONENT SPEAKERS

Product Owners Manual

MOUNTING

Mid-Bass Mounting

The illustration above shows the parts included and correct mounting assembly of the HEX

component mid-bass drivers. Be sure to check the available mounting depth before installation

begins. Use of the foam gasket is recommended to ensure a proper seal between the speaker and

MOUNTING

mounting surface.

Screw Clips

Mid-Bass Mounting

The illustration above shows the parts included and correct mounting assembly of the HEX

component mid-bass drivers. Be sure to check the available mounting depth before installation

begins. Use of the foam gasket is recommended to ensure a proper seal between the speaker and

mounting surface.

Mid-Bass Mounting

Tweeter Mounting

The illustration above shows the parts included and correct mounting assembly of the HEX

When mounting the tweeters, make sure

Tweeter Mounting

component mid-bass drivers. Be sure to check the available mounting depth before installation

desired location can accommodate the

When mounting the tweeters, make sure

begins. Use of the foam gasket is recommended to ensure a proper seal between the speaker and

hole size, over all diameter and depth

desired location can accommodate the

mounting surface.

required. Cut a hole in the surface

hole size, over all diameter and depth

chosen and feed speaker wire through.

required. Cut a 2" hole in the surface

Tweeter Mounting

Remove the tweeter mounting ring by

chosen and feed speaker wire through.

When mounting the tweeters, make sure

unscrewing it counter clockwise. Connect

Remove the tweeter mounting ring by

desired location can accommodate the

speaker wire to tweeter terminals and mount

unscrewing it counter clockwise. Connect speaker

hole size, over all diameter and depth

tweeter in hole using provided screws. When tweeter

wire to tweeter terminals and mount tweeter in hole

required. Cut a 2" hole in the surface

is secure, replace trim ring by screwing it on clockwise.

using provided screws. When tweeter is secure, replace

chosen and feed speaker wire through.

trim ring by screwing it on clockwise.

Remove the tweeter mounting ring by

unscrewing it counter clockwise. Connect speaker

wire to tweeter terminals and mount tweeter in hole

using provided screws. When tweeter is secure, replace

trim ring by screwing it on clockwise.

Gasket

Mounting Ring

Mounting Surface

Pro

™

Mid-bass Driver

Mounting Screws

Pro

™

Mounting Screws

Tweeter

Pro

™