Diamond Audio Technology HP650 Kurulum Kılavuzu - Sayfa 5
Hoparlör Sistemi Diamond Audio Technology HP650 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Diamond Audio Technology HP650 8 sayfaları. Hex pro series 6.5” component system
Sayfayı Yazdır6.5" COMPONENT SPEAKERS
Product Owners Manual
MOUNTING
MOUNTING
Mid-Bass Mounting
The illustration above shows the parts included and correct mounting assembly of the HEX
component mid-bass drivers. Be sure to check the available mounting depth before installation
begins. Use of the foam gasket is recommended to ensure a proper seal between the speaker and
MOUNTING
mounting surface.
Screw Clips
Mid-Bass Mounting
The illustration above shows the parts included and correct mounting assembly of the HEX
component mid-bass drivers. Be sure to check the available mounting depth before installation
begins. Use of the foam gasket is recommended to ensure a proper seal between the speaker and
mounting surface.
Mid-Bass Mounting
Tweeter Mounting
The illustration above shows the parts included and correct mounting assembly of the HEX
When mounting the tweeters, make sure
Tweeter Mounting
component mid-bass drivers. Be sure to check the available mounting depth before installation
desired location can accommodate the
When mounting the tweeters, make sure
begins. Use of the foam gasket is recommended to ensure a proper seal between the speaker and
hole size, over all diameter and depth
desired location can accommodate the
mounting surface.
required. Cut a hole in the surface
hole size, over all diameter and depth
chosen and feed speaker wire through.
required. Cut a 2" hole in the surface
Tweeter Mounting
Remove the tweeter mounting ring by
chosen and feed speaker wire through.
When mounting the tweeters, make sure
unscrewing it counter clockwise. Connect
Remove the tweeter mounting ring by
desired location can accommodate the
speaker wire to tweeter terminals and mount
unscrewing it counter clockwise. Connect speaker
hole size, over all diameter and depth
tweeter in hole using provided screws. When tweeter
wire to tweeter terminals and mount tweeter in hole
required. Cut a 2" hole in the surface
is secure, replace trim ring by screwing it on clockwise.
using provided screws. When tweeter is secure, replace
chosen and feed speaker wire through.
trim ring by screwing it on clockwise.
Remove the tweeter mounting ring by
unscrewing it counter clockwise. Connect speaker
wire to tweeter terminals and mount tweeter in hole
using provided screws. When tweeter is secure, replace
trim ring by screwing it on clockwise.
©2008 Diamond Audio Technologies. All rights reserved.
Gasket
Mounting Ring
Mounting Surface
5
Pro
™
Mid-bass Driver
Mounting Screws
Pro
™
Mounting Screws
Tweeter
Pro
™