AquaSure AS-FP600 소유자 매뉴얼 - 페이지 8
{카테고리_이름} AquaSure AS-FP600에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AquaSure AS-FP600 12 페이지. Whole house water filter
페이지 인쇄
- 1. Table of Contents
- 2. Inspection & Preparation
- 3. Be Familiar with the System before Installation
- 4. System Operation Parameter and Installation Checklist
- 5. Installing the System
- 6. STEP 1. Checking the Direction of Water Flow
- 7. STEP 2. Shutting off the Main Water Supply Valve
- 8. STEP 4. Attaching the Water Supply Pipe
- 9. STEP 5. Installing the Filter
- 10. STEP 6. System Startup
- 11. Limited Product Warranty
STEP 3.
Mounting the System
1. Position the system on the wall at the desired mounting location with minimum of 6 in
ground clearance from the floor to the base of the system.
2. Using a pen or pencil and mark the mounting hole on the back of the bracket onto the
wall.
Note: Please make sure the bracket mount is leveled using a leveling tool to ensure evenly
distributed stress on the bracket. Make sure the mounting point is position on a stud to
properly secure the bracket.
3. Mount the system onto the wall using the provided Lag Bolt and Washer.
STEP 4.
Attaching the Water Supply Pipe
1. Wrap the 1" male threaded fittings (Not Included) with 5 to 6 wraps of Teflon tape.
2. Attached the 1" male threaded fitting from the incoming supply plumbing to the IN port
and OUT port of the system.
6
www.AQUASUREUSA.com
Tel: 1-800-661-0680