3branch Discovery 조립 지침 및 하드웨어 - 페이지 2

{카테고리_이름} 3branch Discovery에 대한 조립 지침 및 하드웨어을 온라인으로 검색하거나 PDF를 다운로드하세요. 3branch Discovery 2 페이지. Activity table system

페이지 인쇄

discovery

activity table system

assembly instructions

Assembly of this product comes down to simple nuts and bolts. The

following directions will get you started. Whether assembling a single

table or a large configuration, these basic steps will provide everything

you need to assemble your product.

discovery

hardware & tool items

n1 nut

b1 bolt

drawer key

SAFETY WARNING

Do not attempt to assemble the table system alone.

Use two people when moving and or attaching components.

Components are heavy. Personal injury or product damage

can occur if precautions are not taken! Be smart, be safe.

check your packing list & unpack

1. Packing list is attached to outside of box

2. Move all packages to intended area for set-up.

3. Unpack Discovery

3branch.com

⅝ flat

allen key

wrench

Ensure you have all Discovery

components.

components. Place the

table in desired location.

877.899.9902

prepare components for assembly

1. For all tables and benches, unlock drawer using a

2. Slowly slide drawer open, ensuring the unit doesn't tip.

3. Locate the holes on the sides of the unit.

insert n1 nut into tables & benches

1. Insert n1 nut in each open hole as shown in image 3.

2. Once all n1 nuts are inserted, you are ready to attach

attach components with b1 bolts

1. With two people, hold components together so that

2. Make sure all b1 bolts are snug before releasing

hand tighten bolts

1. Use the m4 allen key and turn clockwise to hand

2. Repeat step 3 - 5 as needed to complete assembly

adjust table or bench levelers

1. Use

2. Insert wrench under table or bench at the feet.

3. Ensure wrench is seated properly. Turn clockwise to

NOTICE: For end panel and tower components, n1 nuts come embedded

from the factory. Use b1 bolts accordingly to attach these components.

drawer key supplied in hardware bag.

Repeat this step as needed for all tables and benches.

additional components.

all holes align. While holding components in position,

insert b1 bolt and "start" each screw by hand.

weight of attached component.

tighten each bolt snug.

of all components. When complete, add table top

and cushions if applicable.

⅝

flat wrench to adjust level of table or bench.

lower foot; counter-clockwise to raise.