3branch Discovery Instrukcje montażu i sprzęt - Strona 2
Przeglądaj online lub pobierz pdf Instrukcje montażu i sprzęt dla Meble dla niemowląt i małych dzieci 3branch Discovery. 3branch Discovery 2 stron. Activity table system
discovery
activity table system
TM
assembly instructions
Assembly of this product comes down to simple nuts and bolts. The
following directions will get you started. Whether assembling a single
table or a large configuration, these basic steps will provide everything
you need to assemble your product.
discovery
hardware & tool items
TM
n1 nut
b1 bolt
drawer key
SAFETY WARNING
Do not attempt to assemble the table system alone.
Use two people when moving and or attaching components.
Components are heavy. Personal injury or product damage
can occur if precautions are not taken! Be smart, be safe.
check your packing list & unpack
1
1. Packing list is attached to outside of box
2. Move all packages to intended area for set-up.
3. Unpack Discovery
3branch.com
©3branch All Rights Reserved.
⅝ flat
m4
allen key
wrench
Ensure you have all Discovery
TM
components.
TM
components. Place the
table in desired location.
877.899.9902
prepare components for assembly
2
1. For all tables and benches, unlock drawer using a
2. Slowly slide drawer open, ensuring the unit doesn't tip.
3. Locate the holes on the sides of the unit.
insert n1 nut into tables & benches
3
1. Insert n1 nut in each open hole as shown in image 3.
2. Once all n1 nuts are inserted, you are ready to attach
attach components with b1 bolts
4
1. With two people, hold components together so that
2. Make sure all b1 bolts are snug before releasing
hand tighten bolts
5
1. Use the m4 allen key and turn clockwise to hand
2. Repeat step 3 - 5 as needed to complete assembly
adjust table or bench levelers
6
1. Use
2. Insert wrench under table or bench at the feet.
3. Ensure wrench is seated properly. Turn clockwise to
NOTICE: For end panel and tower components, n1 nuts come embedded
from the factory. Use b1 bolts accordingly to attach these components.
drawer key supplied in hardware bag.
Repeat this step as needed for all tables and benches.
additional components.
all holes align. While holding components in position,
insert b1 bolt and "start" each screw by hand.
weight of attached component.
tighten each bolt snug.
of all components. When complete, add table top
and cushions if applicable.
⅝
flat wrench to adjust level of table or bench.
lower foot; counter-clockwise to raise.