3cityElectronics FERMIO-EM 빠른 사용 설명서 - 페이지 5

{카테고리_이름} 3cityElectronics FERMIO-EM에 대한 빠른 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3cityElectronics FERMIO-EM 9 페이지.

3.1. Serial port - FERMIO-EM + debug adapter set is required:

1. attach a debug board to Fermio-EM module using connector (J_DB),

2. connect debug board to Your PC using micro-USB connector,

3. connect power connector (J11) and power-up the board with voltage in range 3.5-17 V,

4. run a software supporting communication over serial port e.g. PuTTY,

5. choose "Connection type" as "Serial",

6. enter a port number to "Serial line", which is assigned to FERMIO-EM,

7. speed transmission set to 115200,

8. run the terminal,

9. log in using "root" username (password not required).

3.2. SSH protocol – knowing FERMIO-EM's IP address is required

1. attach LAN cable to RJ45 connector (J5),

2. connect power connector (J11) and power-up the board with voltage in range 3.5-17 V,

3. run a software supporting communication over serial port e.g. PuTTY,

4. choose "Connection type" as "SSH",

5. in "Host name" field enter IP address of your FERMIO device,

6. set "Port" to 22,

7. run the terminal,

8. log in using "root" username (password not required).

Demo applications are located at /usr/FERMIO.

Fermio-EM : User guide

5/9