Panasonic aw-he40 series 매뉴얼
{카테고리_이름} Panasonic aw-he40 series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic aw-he40 series 4 페이지. Adding another camera to existing system
Panasonic aw-he40 series에 대해서도 마찬가지입니다: 설치 및 설정 매뉴얼 (12 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지)
페이지 인쇄
AW-HE40 & AW-HS50 – Audio (Passing Through) Settings
★ AW-HE40 camera can superimpose the audio signal from an external microphone onto the video signal and can
output it.
Also, it can superimpose the audio onto SDI output through AW-HS50 switcher.
To allow the audio to pass through, both AW-HE40 camera and AW-HS50 switcher require changing the settings.
Schematic View
(AW-HE40)
Microphone
(AW-HE40 Rear Panel)
1．AW-HE40 Audio Settings
(Example 1) Using AW-RP50 Controller
*
Below is the explanation about the audio settings of a camera registered as [CAM1].
① Press the button 1 at <CAMERA STATUS/SELECTION>. – (Fig.1-A)
② Hold down CAMERA OSD button – (Fig.1-B) for 2 seconds to open the on-screen menu. (Hold it down again for 2
seconds to close the menu.)
③ Use F1 dial – (Fig.1-C) to set the item "Audio" to [On].
【Location】 System ＞ Others ＞ Others 4/4 ＞ Audio ⇒ [On] – (Figure 2 of next page)
* When "Audio" is [On], the audio-related setting items are available. Set them according to the installation
environment of your cameras. – (Figure 3 of next page)
（A）
(AW-HS50)
SDI Connection
HDMI Connection (*)
(*) The HDMI model requires an SDI converter
in order to connect with AW-HS50.
Specifications of External Audio Input Connector [AUDIO IN]
- Stereo mini-jack (φ3.5mm)
- Mic input: Input level
* Supported mic: Stereo mic (plug-in power), Supplied voltage: 2.5V±0.5V
- Line input: Input level
(Figure 1: AW-RP50 Control Panel)
SDI Connection
-60dBV±3dBV
-10dBV±3dBV
（B）
（C）
Recorder
(Video & Audio Recording)
* Default: Off