Panasonic aw-he40 series 설치 및 설정 매뉴얼

{카테고리_이름} Panasonic aw-he40 series에 대한 설치 및 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic aw-he40 series 12 페이지. Adding another camera to existing system
Panasonic aw-he40 series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 매뉴얼 (4 페이지), 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄
Panasonic aw-he40 series 설치 및 설정 매뉴얼
Remote Camera Installation & Setup Guide
●This is to explain the procedure for allowing AW-HE40 series cameras to be used via
AW-RP50 controller.
For detailed explanations, please see each Operating Instructions.
1． Connecting the LAN Cable

【IP Connection】

(Point)
Through a hub, AW-RP50 controller can control up to 100 remote cameras.
Connect [LAN] on AW-RP50 rear panel and [LAN ACT/LINK] on AW-HE40 rear panel using a LAN cable.
(AW-RP50 Rear Panel)

【Serial Connection】

(Point)
The cable can be extended up to 1,000m.
AW-RP50 controller can control up to five AW-HE40 cameras via serial connection.
Connect TO PAN/TILT HEAD [1] – [5] on AW-RP50 rear panel and [RS-422] on AW-HE40 rear panel using
a LAN cable.
(AW-RP50 Rear Panel)
※TO PAN/TILT HEAD ports [1] – [5] correspond to AW-RP50 connection settings "CAM1" – "CAM5",
respectively.
If you want to use AW-RP50 "CAM3" for serial controlling of the camera, please connect a LAN cable
with TO PAN/TILT HEAD port [3].
Direct Connection
HUB
(Through a hub)
(AW-HE40 Rear Panel)
(AW-HE40 Rear Panel)
(LAN Cable)
Category 5 or higher, Up to 100m
(LAN Cable)
Category 5 or higher, Up to 100m
<
For
PoE+ Hub >
Category 5e or higher, Up to 100m
(LAN Cable)
Category 5 or higher, Up to 1,000m
Straight cable