Panasonic aw-he40 series 설치 및 설정 매뉴얼 - 페이지 2

{카테고리_이름} Panasonic aw-he40 series에 대한 설치 및 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic aw-he40 series 12 페이지. Adding another camera to existing system
Panasonic aw-he40 series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 매뉴얼 (4 페이지), 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

2．

Operating AW-RP50 Controller to Set Up the Network Connection with AW-HE40 Camera

【Controlling One AW-HE40 Camera via AW-RP50 Controller】

① Press MENU button. - (Fig. 1-A)

② Press [10] SYSTEM button. - (Fig. 1-B)

＊"[1] CAMERA CTL" will be displayed on the LCD screen. - (Fig. 2)

＊ If it is not displayed, turn F1 dial to make "[1] CAMERA CTL" appear.

③ While "[1] CAMERA CTL" is displayed on the LCD, press F1 dial. – (Fig. 1-C)

("[1] CAM1" will be displayed on the upper half, and the connection method (default: [NoAsign]) on the

lower half of the LCD screen.)

＊If it is not displayed, turn F1 dial to make [CAM1] appear.

【IP Connection】

④ Turn F2 dial to select [Network], then press F2 dial to determine the setting. – (Fig. 1-D)

【Serial Connection】

④ Turn F2 dial to select [Serial], then press F2 dial to determine the setting. – (Fig. 1-D)

(Figure 1: AW-RP50 Control Panel)

（A）

If the setting is executed correctly, the LED

marked with

status display lamp of the camera.

Status Display Lamp

〇

will light up according the

(Status Display Lamp ・・・ Shows the camera's power status)

(Figure 2: AW-RP50 LCD Panel)

MENU ON ⇒ Select [10]

（C）

［1］CAMERA CTL

（D）

Press F1

（B）

【IP Connection】

1.CAM1

【Serial Connection】

1.CAM1

Turn F2 to select ⇒ Press F2 to set

Lit in Green ・・・ Turned-On State

(Image is being output.)

Lit in Orange ・・・ Standby Mode (Factory Default)

Turning-on operation needs to be done.

Network

Serial