Panasonic BB-HCM580A 통합 참고 사항 - 페이지 10

{카테고리_이름} Panasonic BB-HCM580A에 대한 통합 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic BB-HCM580A 10 페이지. Power over ethernet (poe) zoom mpeg-4 network camera
Panasonic BB-HCM580A에 대해서도 마찬가지입니다: 운영 매뉴얼 (4 페이지)

페이지 인쇄

OME

OGIC

ONFIGURATION

The following table provides settings used in the HomeLogic Configurator. Please refer to the Configurator Reference Guide for more details.

In the table below:

"<User Defined>", etc.

Devices

Variable Name

Communication Device

N/A (See Note 1)

Video Cameras

Name

Device Type

Location

IP Address

Port

UserName

Password

Low-Res Panning

Flip Image 180

Hide Resolution Control

Hide Full Screen Control

Default Resolution

Goto Preset when Idle

Record Resolution

Record Tolerance

Motion Detect

Software Motion Trigger

Notes:

1. No Communication Device is needed: just add Video Cameras.

2. By default, set the first camera to 192.168.0.80, the second to 192.168.0.81, and so on.

ETAILS

Type in the desired name for the item.

Setting

N/A (See Note 1)

Panasonic KX-HCM280A

<User Defined> (Not Required)

<User Defined> (Default: 192.168.0.80) (See Note 2)

<User Defined> (Default: Administrator)

<User Defined> (Default: password)

<Select> (Default: <No>)

<Select> (Default: <Auto>)

<Select> (Default: <NONE>)

<Select> (Default: <Don't Change>)

<Select> (Default: 0% (Keep All Frames))

<Select> (Default: Disabled)

<Select> (Default: 50%)

Comments

Typically left at 80

Set to YES if camera is inverted

Camera will Pan/Tilt/Zoom as applicable to a certain preset when no streams active.

Don't Change will default to last active resolution, or set a specific resolution for recording

Higher will discard frames with no motion to conserve disk space

Enable to trigger event maps when motion detected (DVR)

Lower is more sensitive.

10 of 10