HP 5120-24G-PoE+ EI 구성 매뉴얼 - 페이지 27
{카테고리_이름} HP 5120-24G-PoE+ EI에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 5120-24G-PoE+ EI 39 페이지. Hp 5120 ei switch series
HP 5120-24G-PoE+ EI에 대해서도 마찬가지입니다: 데이터시트 (17 페이지)
페이지 인쇄
Use dynamic link aggregation mode. MAD is LACP dependent. Even though LACP MAD can be
•
configured on both static and dynamic aggregate interfaces, it takes effect only on dynamic
aggregate interfaces.
Configure link aggregation settings also on the intermediate device.
•
To configure LACP MAD:
Step
1.
Enter system view.
2.
Assign a domain ID to the IRF
fabric.
3.
Create an aggregate
interface and enter
aggregate interface view.
4.
Configure the aggregation
group to operate in dynamic
aggregation mode.
5.
Enable LACP MAD.
6.
Return to system view.
7.
Enter Ethernet interface view.
8.
Assign the Ethernet interface
to the specified aggregation
group.
Configuring ARP MAD
When you configure ARP MAD, follow these guidelines:
Use a VLAN dedicated to ARP MAD.
•
If an intermediate device is used, you can use common data links as ARP MAD links. If no
•
intermediate device is used, set up dedicated ARP MAD links between IRF member devices.
•
If an intermediate device is used, make sure the following requirements are met:
Run the spanning tree feature between the IRF fabric and the intermediate device.
Enable the IRF fabric to change its bridge MAC address as soon as the master leaves.
Create an ARP MAD VLAN and assign the ports on the ARP MAD links to the VLAN.
If the intermediate device is in an IRF fabric, assign this fabric a different domain ID than the
ARP MAD-enabled fabric to avoid false detection of IRF splits.
Command
system-view
irf domain domain-id
interface bridge-aggregation
interface-number
link-aggregation mode dynamic
mad enable
quit
interface interface-type
interface-number
port link-aggregation group number
23
Remarks
N/A
The default IRF domain ID is 0.
Use either command.
Perform this step also on the
intermediate device.
By default, an aggregation
group operates in static
aggregation mode.
Perform this step also on the
intermediate device.
By default, LACP MAD is
disabled.
N/A
N/A
Perform this step on the
intermediate device as well.