HP 5120-24G-PoE+ EI 구성 매뉴얼 - 페이지 29
{카테고리_이름} HP 5120-24G-PoE+ EI에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 5120-24G-PoE+ EI 39 페이지. Hp 5120 ei switch series
HP 5120-24G-PoE+ EI에 대해서도 마찬가지입니다: 데이터시트 (17 페이지)
페이지 인쇄
CAUTION:
Excluding a VLAN interface and its Layer 2 ports from the shutdown action introduces IP collision risks
because the VLAN interface might be active on both the IRF fabric in Active state and the IRF fabric in
Recovery state.
By default, all ports except the console and physical IRF ports automatically shut down when the IRF
fabric transits to the Recovery state.
You can exclude a port from the shutdown action for management or other special purposes. For
example:
Exclude a port from the shutdown action, so you can Telnet to the port for managing the switch.
•
Exclude a VLAN interface and its Layer 2 ports from the shutdown action, so you can log in through
•
the VLAN interface.
To configure a port to not shut down when the IRF fabric transits to the recovery state:
Step
1.
Enter system view.
2.
Configure a port to not shut
down when the IRF fabric
transits to the Recovery state.
Recovering an IRF fabric
After the failed IRF link between two split IRF fabrics is recovered, log in to the Recovery-state IRF fabric,
and use the reboot command to reboot all its members. After these member switches join the Active-state
IRF fabric as subordinates, IRF merge is complete, as shown in
Figure 10 Recovering the IRF fabric
If the Active-state fabric has failed, for example, because of device or link failures, before the IRF link is
recovered (see
to Active for forwarding traffic. After you repair the IRF link, the two parts merge into a unified IRF fabric.
Command
system-view
mad exclude interface interface-type
interface-number
Figure 1
1), use the mad restore command on the Recovery-state fabric to change its state
Figure
25
Remarks
N/A
By default, when an IRF fabric
transits to the Recovery state, all
its network ports but the IRF
physical ports and console port
are shut down.
10.