AQUATECH Strike Flash 사용 설명서 - 페이지 2
{카테고리_이름} AQUATECH Strike Flash에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AQUATECH Strike Flash 2 페이지.
페이지 인쇄Instructions:
Place the flash inside the Flash Housing, lock
into place using the flash hot shoe lock on
your flash. Ensure the main O-Ring is in place
and clear from any dirt or grit. Tighten the back
plate onto the Flash Housing with the M6x18
Bolts, take care to evenly tighten and DO NOT
over tighten. You should see an even amount
of pressure on the O-Ring completely around
the seal.
Attach the Flash Mount to the centre of your
Sport Housing using the two supplied bolts
and the 4mm Hex key. Place the Flash Housing
into the mount and lock into place using the
bolt located in the base of the Flash Housing.
Remove the flash Sync bulk head caps from
both the flash housing and the Sport Housing.
Please ensure there is small O-Ring sitting
in the groove of these flash sync Bulk heads.
Connect the Sync Cord to the flash Sync bulk
head on both the Sport Housing and Flash
Housing. Applied downward pressure to lock
into place and tighten via screwing the sync
lead cap into place. Please Take care not to
over tighten as this may split the O-Ring.
Connect the Camera Hot Shoe connector
into the internal flash connection of the
Sport Housing. These are Male / Female pin
configuration and should be connected with
care as parts are very fragile.
Before placing your camera inside the Sport
Housing, slide the Hot Shoe connector onto the
Hot Shoe of your camera. Carefully slide your
camera into place and test the flash before
entering the water.
IMPORTANT:
-Do not over tighten the Backplate when
sealing. Doing so can damage the Flash Sport
Housing.