AQUATECH Strike Flash Kullanım Kılavuzu - Sayfa 2

Kamera Aksesuarları AQUATECH Strike Flash için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. AQUATECH Strike Flash 2 sayfaları.

Instructions:

Place the flash inside the Flash Housing, lock

into place using the flash hot shoe lock on

your flash. Ensure the main O-Ring is in place

and clear from any dirt or grit. Tighten the back

plate onto the Flash Housing with the M6x18

Bolts, take care to evenly tighten and DO NOT

over tighten. You should see an even amount

of pressure on the O-Ring completely around

the seal.

Attach the Flash Mount to the centre of your

Sport Housing using the two supplied bolts

and the 4mm Hex key. Place the Flash Housing

into the mount and lock into place using the

bolt located in the base of the Flash Housing.

Remove the flash Sync bulk head caps from

both the flash housing and the Sport Housing.

Please ensure there is small O-Ring sitting

in the groove of these flash sync Bulk heads.

Connect the Sync Cord to the flash Sync bulk

head on both the Sport Housing and Flash

Housing. Applied downward pressure to lock

into place and tighten via screwing the sync

lead cap into place. Please Take care not to

over tighten as this may split the O-Ring.

Connect the Camera Hot Shoe connector

into the internal flash connection of the

Sport Housing. These are Male / Female pin

configuration and should be connected with

care as parts are very fragile.

Before placing your camera inside the Sport

Housing, slide the Hot Shoe connector onto the

Hot Shoe of your camera. Carefully slide your

camera into place and test the flash before

entering the water.

IMPORTANT:

-Do not over tighten the Backplate when

sealing. Doing so can damage the Flash Sport

Housing.