AQUATECH Strike Flash Kullanım Kılavuzu

Kamera Aksesuarları AQUATECH Strike Flash için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. AQUATECH Strike Flash 2 sayfaları.

Strike Flash Housing

Instruction Manual

FEATURES:

Flash Housing- Clear casing that suits

your professional flash.

Flash Bolts- Included are four M6x18

bolts. Three are used for sealing the Flash

Sport Housing and there is one extra

included for back up.

Grey Sealing O-Ring- This o-ring seals

between the Backplate and Flash Sport

Housing.

Flash Mount- Bolts to the top of your Sport Housing

using two M5x10 bolts.

Flash Bulkhead- The (black) dry connector located

on the side of your Flash Sport Housing. The flash

bulkhead is only waterproof if the cap is on or if the

sync cord is connected.

Sync Cord- The 16 inch (400mm) cable that

connects between your Flash Sport Housing and

Camera Sport Housing. This cord is only waterproof

if caps are screwed on or if it is connected to your

Flash Sport Housing and Camera Sport Housing.

Camera Hot Shoe- This piece connects to the hot

shoe of your camera then to the Flash Bulkhead

wires on the inside of your housing. This piece is

fragile so handle with care.

6mm Hex Key- This tool is used for tightening down

the Flash Sport Housing to the mount.

5mm Hex Key- This tool is used to bolt down the

Backplate.

4mm Hex Key- This tool is used to bolt down the

Flash Mount.