HP ProCurve 1600M 설치 매뉴얼 - 페이지 8

{카테고리_이름} HP ProCurve 1600M에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP ProCurve 1600M 28 페이지. Redundant power supply
HP ProCurve 1600M에 대해서도 마찬가지입니다: 사양 시트 (12 페이지), 먼저 읽기 (8 페이지), 검토자 매뉴얼 (27 페이지), 보충 설명서 (2 페이지), 보충 설명서 (2 페이지), 설치 매뉴얼 (28 페이지), 설치 매뉴얼 (36 페이지), 빠른 설정 매뉴얼 (2 페이지), 빠른 설정 매뉴얼 (4 페이지), 사용자 설명서 (8 페이지), 매뉴얼 보충 자료 (28 페이지), 먼저 읽기 (16 페이지), 설치 및 제거 (2 페이지), 설치 매뉴얼 (12 페이지), 계획 및 구현 매뉴얼 (40 페이지), 제품 수명이 다한 제품 분해 지침 (2 페이지), 설치 매뉴얼 (46 페이지), 진단 매뉴얼 (2 페이지), 분해 지침 (2 페이지)

Installing the Module

N o t e

Installing the Module

You can install the Gigabit Stacking Module into only the HP ProCurve Switch

2424M. The installation steps are:

1. Verify that your HP ProCurve Switch 2424M has the correct operating

system software (OS) version. Switch 2424M units that were shipped

before the Gigabit Stacking Module became available may be running

software that does not support the module. The switch must be running

OS version C.06.06 or later to support the Gigabit Stacking Module (see

page 3).

Install new software, if needed. The new software is found on the floppy

disk included with the module. You can also copy the OS file from the HP

networking products world wide web site:

http://www.hp.com/go/procurve

The software files to download are located under the [Support] button on that

web page.

2. Install transceivers into the module transceiver slots (see page 5).

3. Install the module in the Switch 2424M slot (see page 6).

4. Verify that the module is installed correctly (see page 7).

5. Connect the network cabling (see page 8).

6. Reset the switch, if you have installed the module into a slot that was

previously occupied by a different type module (see page 10).

7. Optionally, customize the configuration for the module's ports (unless the

default port configuration is satisfactory for your network environment -

see page 11).

If necessary, you can "hot-swap" one module for another; that is, replace one

module with another of the same type while the switch is still powered on,

without interrupting the operation of the rest of the switch ports. You can also

install the module into the unused switch slot without interrupting the switch

operation. For more information, see page 16.