HP ProCurve 8116fl 제품 수명이 다한 제품 분해 지침 - 페이지 2
{카테고리_이름} HP ProCurve 8116fl에 대한 제품 수명이 다한 제품 분해 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. HP ProCurve 8116fl 4 페이지. Redundant switch fabric module
HP ProCurve 8116fl에 대해서도 마찬가지입니다: 데이터시트 (6 페이지), 제품 수명이 다한 제품 분해 지침 (9 페이지)
페이지 인쇄
radioactive substances
2.0 Tools Required
List the type and size of the tools that would typically be used to disassemble the product to a point where components
and materials requiring selective treatment can be removed.
Tool Description
Philips Head Screw Driver
3.0 Product Disassembly Process
3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment:
1.
Carefully detach the cable that is connecting the LEDs on one end of the bulkhead and the PCA on the other end.
Refer to Picture 1 for more details.
2. Remove the screws securing the bulkhead to PCA using a Philips screw driver (4 per for J8730A).
3. Remove the EMI gasket from the top (1 per) and the side (2 per) of the bulkhead. Refer to Picture 2 for more details.
4. Remove the screws securing the clip to heat sink using a Philips screw driver (24 per for J8730A). Refer to Picture 3
for more details
5. Separate the clip (12 per for J8730A) & standoff (24 for J8730A) from the heat sink.
6. Remove the screws securing the guide pins to the PCA using a Philips screw driver (3 per for J8730A). Refer to
Picture 4 for more details.
7. Separate the guide pins, heat sink, clip, standoff, EMI gasket, cable, PCA and bulkhead
8.
9.
10. .
11.
12.
13.
14.
15.
16.
3.2 Optional Graphic. If the disassembly process is complex, insert a graphic illustration below to identify the items
contained in the product that require selective treatment (with descriptions and arrows identifying locations).
EL-MF877-00
Template Revision A
Tool Size (if
applicable)
# 2
Page 2