HP ProCurve J8766A 설치 매뉴얼 - 페이지 25
{카테고리_이름} HP ProCurve J8766A에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP ProCurve J8766A 48 페이지. Hp procurve switch vl modules
HP ProCurve J8766A에 대해서도 마찬가지입니다: 먼저 읽기 (4 페이지), 빠른 참조 매뉴얼 (44 페이지)
페이지 인쇄
C a u t i o n
Replacing or Removing a Module
Follow these procedures to replace one module with another, or to remove a
module without replacing it:
1.
Remove any network cables from the ports on the module to be removed.
2.
Unscrew the retaining screws enough to disconnect them from the
threaded holes in the switch.
Figure 13. Retaining screws
3.
Grab the screws and pull the module out from the slot. It may help to brace
your hands against the face of the switch and "lever" the module out from
the switch slot.
4.
Do one of the following:
•
If you will be installing another module in the slot, go to "Installing
the Module in an Unused Slot" on
•
If you will not install another module in the slot (that is, leave it
empty), then re-install a slot cover plate over the empty slot opening.
For proper cooling and reduction of electromagnetic emissions, ensure a slot
cover is installed on any unused slot.
5.
If you are replacing a module with another one of the same type in the
same slot, it is not necessary to reset the switch. The current configuration
for ports in that slot will apply to the new module.
If you are exchanging one type of module with a different type of module
in the same slot (for example, replacing a 10/100-TX vl Module with a
Gig-T vl Module), you must reset the switch as described under "Resetting
the Switch" on
page
unscrew the retaining screws
page 7
20.
ProCurve Switch vl Modules
Replacing or Removing a Module
and begin with step 2.
19